Commercial Electrician in Kirkland, WA

Konsker Electric handles commercial electrical for Kirkland, WA businesses start to finish: tenant improvement wiring, LED retrofits with the lighting controls current energy code requires, service and panel work across 120/208V and 277/480V up to 600V, and documented code compliance inspections. Kirkland sits in King County outside Seattle city limits, so we pull the Washington State L&I electrical permit, coordinate the disconnect and reconnect with Puget Sound Energy when the job touches the service, and give you a flat-rate quote in writing before any work begins. Licensed, bonded, and insured for 20+ years. Call (206) 260-1981.

Tenant Improvement Electrical in Kirkland

A Kirkland tenant improvement runs on two permits, and confusing them is where buildouts stall. The electrical permit is separate from the general contractor's building permit and, per Washington rules, has to be pulled by the licensed electrical contractor, not the GC. We meter the existing service, size the panel and feeders for the new tenant loads, and sequence the rough-in around framing so the electrical is not the item holding up occupancy along the Kirkland Urban blocks or the Totem Lake corridor. See our commercial construction and tenant improvement service for the full head-term scope.

LED Retrofits and Service Work to 600V

Commercial LED retrofits are estimate-driven, not flat-priced, because the honest number depends on fixture count, whether you are relamping troffers or swapping housings, and whether you are adding the occupancy and daylight controls Washington State Energy Code requires. We flag any Puget Sound Energy commercial lighting rebate the retrofit qualifies for, and we handle service and panelboard work across 120/208V and 277/480V three-phase systems up to 600 volts. The same crew covers our commercial maintenance and LED upgrades.

Code Compliance Inspections and Permits, Handled

We document commercial code compliance inspections against WAC 296-46B and the 2023 NEC, covering NEC 110.26 working clearances, panel labeling, grounding, and emergency and exit lighting, with a written report and photos within 24 hours. Because Kirkland sits outside Seattle city limits, the electrical permit runs through Washington State L&I rather than Seattle DCI, and we pull it, schedule the inspection, and book the PSE window for you. Read our commercial code compliance inspections service, the wider licensed electrician in Kirkland city page, or our commercial electrician in Federal Way page for south King County buildouts, or browse all commercial electrical services.